Click here for a detailed walkthrough
- Disassemble your Game Boy Advance
- Desolder and remove crystal X1
- Place the GBAccelerator on the PCB between the ARM processor and the cartridge connector as shown in the diagram (click diagram to enlarge)
- Make connections as shown in the diagram
- Reassemble your GBA

GBAccelerator Connections
|
GND |
Cartridge Connector Pin 32 (GND) |
V+ |
Cartridge Connector Pin 1 (S1) |
CLK |
CK1 |
LED |
DL2A |
BUTTON |
TP2 |
BUTTON |
TP8 |
BUTTON |
TP9 |
Installation Tips
- Use low-wattage, fine-tipped soldering iron
- Use flux or rosin-core solder
- Don’t hold the iron on the GBAccelerator or the GBA board too long as you may lift the solder pad
- solid 30-gauge wire is recommended
- Follow wire routing indicated in diagram so wires don’t cross button pads, screw holes, or tall components
- Cut off excess wire length
- The three button connections on the GBAccelerator are interchangeable; it does not matter which one goes to which button
- If alternate button assignments are desired, see button signal list for available connection points