No Reset Snapback Installation Guide | RockerGaming | Hand Held Legend

The following guide shows the installation process for the @RockerGamingMods and @itskwilson no reset snapback mod

If you want to see this in video format refer to the following video  - https://youtu.be/DqofaLC5_oc?t=278

Tools required:


NOTE - All kits purchased after 11/18/21 directly from RG or HHL will contain 2 mounts the black mount will be for a standard install WITHOUT Shinewave.  The white mount should be used WITH Shinwave.


OPTIONAL, but recommended

  • Softmodded Wii with Smash Scope homebrew installed 

Step 1 - Open the Shell with your Tri-Wing Screwdriver



2 - Remove Ruble bracket


3 - Make necessary cuts to the Rumble Bracket with your flush cuts

4 - Solder the 4 wires from the wiring harness to the thumbstick potentiometer



5 - Replace rumble bracket and make sure the wires from the harness route out the bottom through the cuts we made before



6 - plug in the wiring harness to the snap back board



7 - Mount snapback board to the controller pcb



8 - tune the snapback kit, refer to the video below.

https://youtu.be/DqofaLC5_oc?t=631


Link to Smashscope for your modded Wii - https://goomwave.com/wp-content/uploads/2020/06/SmashScope.zip


Link to this guide- https://docs.google.com/document/d/1vTHH3v_ZyUKRBclqKstmgJAUR5obJGCDNgq7Z_Vxuhw/edit?usp=sharing