No Reset Snapback Mod for GameCube Controller

This Snapback flex pcb prevents your stick flicks from rebounding and causing false inputs during gameplay in games such as Smash Bros Melee and Smash Bros Ultimate.
This mod is a solder-in-place flex cable with no trimming required. This is a “No-Reset” module, meaning you do not need to reset the controller after plugging it in to ensure the stick is centered.

INSTRUCTIONS:

• Open Controller with Triwing Screw Driver.
• Remove Rumble bracket.
• Soldering required: Line up the flex PCB with the controller PCB. Solder the 4 gold connection points.
• Replace rumble bracket.
• There may be a protective yellow film covering the switches. This can be removed without any issues.
• Use a soft plastic tool or toothpick to adjust the capacitor switches. Firmly grasp the sides of the switch housing while making adjustments to avoid damage.
• Tested only with original GameCube controllers.

We carry some helpful tools for this mod:

• Flush Cutting Pliers
  
• Tri Wing Screwdriver
• Solder Wick

INSTALLATION

• Controller Disassembly Guide
• Install Guide
  

INCLUDED

• 1 x Snapback PCB board