The No Reset Snapback Mod prevents your GameCube controller thumbstick from crossing into other directions after releasing your thumb off of it. As in, no rocking or swing back after quick inputs.
INSTRUCTIONS:
- Open Controller with Triwing Screw Driver.
- Remove Rumble bracket.
- Make necessary cuts to the Rumble Bracket, refer to the pictures/ Install Diagram.
- Soldering required: Solder the 4 wires from the wiring harness to the thumbstick potentiometer.
- Replace rumble bracket.
- Plug in the wiring harness to the snap back board.
- Mount snapback board to the controller PCB.
- Tune the snapback kit, refer to video below.
We carry some helpful tools for this mod:
INSTALLATION:
INCLUDED
- 1 x Snapback PCB board
- 1 x Wiring harness
- 1 x Attached black mount
- 1x White mount: Only needed if using with the Shinewave LED Mod Kit.
PAIRS WELL WITH:
Check out more by RockerGaming